SuperSlicer/tests/data/fff_print_tests/test_gcodewriter/config_lift_unlift.ini

before_layer_gcode = 
between_objects_gcode = 
end_filament_gcode = "; Filament-specific end gcode \n;END gcode for filament\n"
end_gcode = M104 S0 ; turn off temperature\nG28 X0  ; home X axis\nM84     ; disable motors\n
extrusion_axis = E
extrusion_multiplier = 1
filament_cost = 0
filament_density = 0
filament_diameter = 3
filament_max_volumetric_speed = 0
gcode_comments = 0
gcode_flavor = reprap
layer_gcode = 
max_print_speed = 80
max_volumetric_speed = 0
retract_length = 2
retract_length_toolchange = 10
retract_lift = 1.5
retract_lift_above = 0
retract_lift_below = 0
retract_restart_extra = 0
retract_restart_extra_toolchange = 0
retract_speed = 40
start_filament_gcode = "; Filament gcode\n"
start_gcode = G28 ; home all axes\nG1 Z5 F5000 ; lift nozzle\n
toolchange_gcode = 
travel_speed = 130
use_firmware_retraction = 0
use_relative_e_distances = 0
use_volumetric_e = 0