| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859 |
- [general]
- definition = ultimaker_methodx
- name = Fast
- version = 4
- [metadata]
- material = ultimaker_nylon12-cf_175
- quality_type = draft
- setting_version = 23
- type = quality
- variant = LABS
- weight = -2
- [values]
- cool_fan_enabled = False
- cool_min_temperature = =material_print_temperature-5
- material_final_print_temperature = =material_print_temperature if extruder_nr == support_extruder_nr else (material_print_temperature - 5)
- material_initial_print_temperature = =material_print_temperature if extruder_nr == support_extruder_nr else (material_print_temperature - 5)
- min_wall_line_width = 0.35
- raft_airgap = =0.2 if extruder_nr == support_extruder_nr else 0
- raft_base_line_spacing = 3
- raft_base_line_width = =1 if extruder_nr == support_extruder_nr else 1.2
- raft_base_speed = 10
- raft_base_thickness = =0.6 if extruder_nr == support_extruder_nr else 0.8
- raft_base_wall_count = =2 if extruder_nr == support_extruder_nr else 1
- raft_interface_layers = =1 if extruder_nr == support_extruder_nr else 2
- raft_interface_line_spacing = =1 if extruder_nr == support_extruder_nr else 0.9
- raft_surface_layers = =3 if extruder_nr == support_extruder_nr else 2
- raft_surface_thickness = =0.25 if extruder_nr == support_extruder_nr else 0.2
- retraction_amount = 0.5
- retraction_min_travel = 3.2
- small_skin_width = 3.6
- speed_prime_tower = 30.0
- speed_print = 120.0
- speed_roofing = 55
- speed_topbottom = 55
- speed_travel = 250.0
- speed_wall_0 = 45
- speed_wall_x = 65
- support_angle = 50
- support_bottom_density = 24
- support_bottom_enable = False
- support_bottom_line_width = 0.6
- support_bottom_stair_step_height = 0
- support_infill_rate = 12.0
- support_interface_enable = True
- support_interface_pattern = lines
- support_line_width = 0.3
- support_material_flow = 90
- support_pattern = lines
- support_roof_density = 85
- support_roof_line_width = =0.4 if extruder_nr == support_extruder_nr else 0.25
- support_use_towers = True
- support_xy_distance = =0.3 if extruder_nr == support_extruder_nr else 0.2
- support_xy_distance_overhang = =0.3 if extruder_nr == support_extruder_nr else 0.15
- support_z_distance = 0.35
- wall_overhang_angle = 30
- wall_overhang_speed_factor = 60
|
