[general]
definition = ultimaker_methodx
name = Fast
version = 4

[metadata]
material = ultimaker_nylon12-cf_175
quality_type = draft
setting_version = 23
type = quality
variant = LABS
weight = -2

[values]
cool_fan_enabled = False
cool_min_temperature = =material_print_temperature-5
material_final_print_temperature = =material_print_temperature if extruder_nr == support_extruder_nr else (material_print_temperature - 5)
material_initial_print_temperature = =material_print_temperature if extruder_nr == support_extruder_nr else (material_print_temperature - 5)
min_wall_line_width = 0.35
raft_airgap = =0.2 if extruder_nr == support_extruder_nr else 0
raft_base_line_spacing = 3
raft_base_line_width = =1 if extruder_nr == support_extruder_nr else 1.2
raft_base_speed = 10
raft_base_thickness = =0.6 if extruder_nr == support_extruder_nr else 0.8
raft_base_wall_count = =2 if extruder_nr == support_extruder_nr else 1
raft_interface_layers = =1 if extruder_nr == support_extruder_nr else 2
raft_interface_line_spacing = =1 if extruder_nr == support_extruder_nr else 0.9
raft_surface_layers = =3 if extruder_nr == support_extruder_nr else 2
raft_surface_thickness = =0.25 if extruder_nr == support_extruder_nr else 0.2
retraction_amount = 0.5
retraction_min_travel = 3.2
small_skin_width = 3.6
speed_prime_tower = 30.0
speed_print = 120.0
speed_roofing = 55
speed_topbottom = 55
speed_travel = 250.0
speed_wall_0 = 45
speed_wall_x = 65
support_angle = 50
support_bottom_density = 24
support_bottom_enable = False
support_bottom_line_width = 0.6
support_bottom_stair_step_height = 0
support_infill_rate = 12.0
support_interface_enable = True
support_interface_pattern = lines
support_line_width = 0.3
support_material_flow = 90
support_pattern = lines
support_roof_density = 85
support_roof_line_width = =0.4 if extruder_nr == support_extruder_nr else 0.25
support_use_towers = True
support_xy_distance = =0.3 if extruder_nr == support_extruder_nr else 0.2
support_xy_distance_overhang = =0.3 if extruder_nr == support_extruder_nr else 0.15
support_z_distance = 0.35
wall_overhang_angle = 30
wall_overhang_speed_factor = 60