netdata/collectors/python.d.plugin/am2320

AM2320 sensor monitoring with netdata

Displays a graph of the temperature and humidity from a AM2320 sensor.

Requirements

• Adafruit Circuit Python AM2320 library
• Adafruit AM2320 I2C sensor
• Python 3 (Adafruit libraries are not Python 2.x compatible)

It produces the following charts:

1. Temperature
2. Humidity

Configuration

Edit the python.d/am2320.conf configuration file using edit-config from the Netdata config directory, which is typically at /etc/netdata.

cd /etc/netdata   # Replace this path with your Netdata config directory, if different
sudo ./edit-config python.d/am2320.conf

Raspberry Pi Instructions:

Hardware install: Connect the am2320 to the Raspberry Pi I2C pins

Raspberry Pi 3B/4 Pins:

• Board 3.3V (pin 1) to sensor VIN (pin 1)
• Board SDA (pin 3) to sensor SDA (pin 2)
• Board GND (pin 6) to sensor GND (pin 3)
• Board SCL (pin 5) to sensor SCL (pin 4)

You may also need to add two I2C pullup resistors if your board does not already have them. The Raspberry Pi does have internal pullup resistors but it doesn't hurt to add them anyway. You can use 2.2K - 10K but we will just use 10K. The resistors go from VDD to SCL and SDA each.

Software install:

• sudo pip3 install adafruit-circuitpython-am2320
• edit /etc/netdata/netdata.conf
• find [plugin:python.d]
• add command options = -ppython3
• save the file.
• restart the netdata service.
• check the dashboard.