netdata/collectors/python.d.plugin/smartd_log

smartd_log

Module monitor smartd log files to collect HDD/SSD S.M.A.R.T attributes.

Requirements:

• smartmontools

It produces following charts for SCSI devices:

1. Read Error Corrected

2. Read Error Uncorrected

3. Write Error Corrected

4. Write Error Uncorrected

5. Verify Error Corrected

6. Verify Error Uncorrected

7. Temperature

For ATA devices:

1. Read Error Rate

2. Seek Error Rate

3. Soft Read Error Rate

4. Write Error Rate

5. SATA Interface Downshift

6. UDMA CRC Error Count

7. Throughput Performance

8. Seek Time Performance

9. Start/Stop Count

10. Power-On Hours Count

11. Power Cycle Count

12. Unexpected Power Loss

13. Spin-Up Time

14. Spin-up Retries

15. Calibration Retries

16. Temperature

17. Reallocated Sectors Count

18. Reserved Block Count

19. Program Fail Count

20. Erase Fail Count

21. Wear Leveller Worst Case Erase Count

22. Unused Reserved NAND Blocks

23. Reallocation Event Count

24. Current Pending Sector Count

25. Offline Uncorrectable Sector Count

26. Percent Lifetime Used

prerequisite

smartd must be running with -A option to write smartd attribute information to files.

For this you need to set smartd_opts (or SMARTD_ARGS, check smartd.service content) in /etc/default/smartmontools:

# dump smartd attrs info every 600 seconds
smartd_opts="-A /var/log/smartd/ -i 600"

smartd appends logs at every run. It's strongly recommended to use logrotate for smartd files.

configuration

local:
  log_path : '/var/log/smartd/'

If no configuration is given, module will attempt to read log files in /var/log/smartd/ directory.

---