marlinfw/buildroot/tests/teensy31

#!/usr/bin/env bash
#
# Build tests for Teensy 3.1/3.2 (ARM Cortex-M4)
#

# exit on first failure
set -e

restore_configs
opt_set MOTHERBOARD BOARD_TEENSY31_32
exec_test $1 $2 "Teensy3.1 with default config" "$3"

#
# Zero endstops, as with a CNC
#
restore_configs
opt_set MOTHERBOARD BOARD_TEENSY31_32 X_HOME_DIR 0 Y_HOME_DIR 0 Z_HOME_DIR 0
opt_disable USE_XMIN_PLUG USE_YMIN_PLUG USE_ZMIN_PLUG
exec_test $1 $2 "Teensy3.1 with Zero Endstops" "$3"

#
# Test many features together
#
restore_configs
opt_set MOTHERBOARD BOARD_TEENSY31_32 \
        TEMP_SENSOR_0 1 TEMP_SENSOR_BED 1 \
        I2C_SLAVE_ADDRESS 63 \
        GRID_MAX_POINTS_X 16
opt_enable EEPROM_SETTINGS FILAMENT_WIDTH_SENSOR CALIBRATION_GCODE BAUD_RATE_GCODE \
           FIX_MOUNTED_PROBE Z_SAFE_HOMING AUTO_BED_LEVELING_BILINEAR DEBUG_LEVELING_FEATURE Z_MIN_PROBE_REPEATABILITY_TEST \
           BABYSTEPPING BABYSTEP_XY BABYSTEP_ZPROBE_OFFSET PRINTCOUNTER SLOW_PWM_HEATERS PIDTEMPBED \
           INCH_MODE_SUPPORT TEMPERATURE_UNITS_SUPPORT M100_FREE_MEMORY_WATCHER \
           NOZZLE_PARK_FEATURE NOZZLE_CLEAN_FEATURE PARK_HEAD_ON_PAUSE \
           ARC_SUPPORT BEZIER_CURVE_SUPPORT EXPERIMENTAL_I2CBUS EXTENDED_CAPABILITIES_REPORT AUTO_REPORT_TEMPERATURES \
           PHOTO_GCODE PHOTO_POSITION PHOTO_SWITCH_POSITION PHOTO_SWITCH_MS PHOTO_DELAY_MS PHOTO_RETRACT_MM \
           HOST_ACTION_COMMANDS HOST_PROMPT_SUPPORT
exec_test $1 $2 "Teensy3.1 with many features" "$3"