page:Layers and perimeters:layers
group:Layers
	setting:layer_height
	setting:faded_layers

page:Supports:support
group:Supports
	setting:supports_enable
group:Support head
	setting:support_head_front_diameter
	setting:support_head_penetration
	setting:support_head_width
group:Support pillar
	setting:support_pillar_diameter
	setting:support_small_pillar_diameter_percent
	setting:support_max_bridges_on_pillar
	setting:support_pillar_connection_mode
	setting:support_buildplate_only
# TODO: This parameter is not used at the moment.
# setting:support_pillar_widening_factor
	setting:support_base_diameter
	setting:support_base_height
	setting:support_base_safety_distance
# Mirrored parameter from Pad page for toggling elevation on the same page
	setting:support_object_elevation
	support_object_elevation_description
group:Connection of the support sticks and junctions
	setting:support_critical_angle
	setting:support_max_bridge_length
	setting:support_max_pillar_link_distance
group:Automatic generation
	setting:support_points_density_relative
	setting:support_points_minimal_distance

page:Pad:pad
group:Pad
	setting:pad_enable
	setting:pad_wall_thickness
	setting:pad_wall_height
	setting:pad_brim_size
	setting:pad_max_merge_distance
# TODO: Disabling this parameter for the beta release
# setting:pad_edge_radius
	setting:pad_wall_slope
	setting:pad_around_object
	setting:pad_around_object_everywhere
	setting:pad_object_gap
	setting:pad_object_connector_stride
	setting:pad_object_connector_width
	setting:pad_object_connector_penetration

page:Hollowing:hollowing
group:Hollowing
	setting:hollowing_enable
	setting:hollowing_min_thickness
	setting:hollowing_quality
	setting:hollowing_closing_distance

page:Advanced:wrench
group:Slicing
	setting:slice_closing_radius

page:Output options:output+page_white
group:Output file
	setting:full_width:output_filename_format

page:Dependencies:wrench
group:Profile dependencies
	setting:color:compatible_printers
	setting:full_width:compatible_printers_condition
	parent_preset_description