Marlin-Ender-3/config/examples/FlyingBear/P905H

Flying Bear P905H configuration

This configuration is for a P905H with a single extruder and inductive Z-sensor. It's been thoroughly tested, and I've tried to make the printer work smoothly, so this configuration is more focused on print quality than speed.

• Use this firmware as a baseline for other P905 modifications.
• Find other notes in the config files by searching for "P905H".

Build Instructions

• Get Visual Studio Code and install the "Auto Build Marlin" extension.
• Download the Marlin source code.
• Copy the two Configuration files from this folder into the 'Marlin' folder (replacing the existing files).
• Open the 'MarlinFirmware' project folder in Visual Studio Code.
• Click the "Auto Build Marlin" button and then the Upload button.
• Don't forget to reset your EEPROM with M502 and M500 after flashing.