Marlin-Ender-3/config/examples/Eryone/Thinker V2

Eryone Thinker V2

• BLTouch probe
• Filament runout Sensor

How to use the config

Check the hardware of your printer

1. If you're using the stock printer there's need to modify the config.
2. If you're using the Filament Runout Sensor:
   • Enable this line (Remove the "//" prefix)
     //#define THINKERV2_FL // Enable for an installed Filament runout sensor
3. You are using the Bltouch:
   • Enable this line (Remove the "//" prefix)
     //#define THINKERV2_BLTOUCH // Enable for an installed BLTOUCH
4. You are using the direct drive extruder:
   • Enable this line (Remove the "//" prefix)
     //#define THINKERV2_Direct // Enable for Direct drive extruder system
5. Can I use all of the mods? The answer is yes. You can use all of them or just some of them.
6. If your printer's PSU has a reset problem you can disable the PIDTEMPBED feature:
   • Disable this line (Prefix with "//")
     #define PIDTEMPBED // If your PSU has a reset problem then try to disable it to improve this problem

Have fun :)