Cura/resources/definitions/bq_witbox.def.json

{
    "version": 2,
    "name": "BQ Witbox",
    "inherits": "fdmprinter",
    "metadata": {
        "visible": true,
        "author": "BQ",
        "manufacturer": "BQ",
        "file_formats": "text/x-gcode",
        "platform": "bq_witbox_platform.3mf",
        "platform_offset": [ 0, -145, -38],
        "machine_extruder_trains":
        {
            "0": "bq_witbox_extruder_0"
        },
        "firmware_file": "MarlinWitbox.hex"
    },

    "overrides": {
        "machine_name": { "default_value": "BQ Witbox" },
        "machine_start_gcode": {
            "default_value": "; -- START GCODE --\nG21                     ;set units to millimetres\nG90                     ;set to absolute positioning\nM106 S0                 ;set fan speed to zero (turned off)\nG28 X0 Y0               ;move to the X/Y origin (Home)\nG28 Z0                  ;move to the Z origin (Home)\nG1 Z15.0 F1200          ;move Z to position 15.0 mm\nG92 E0                  ;zero the extruded length\nG1 E20 F200             ;extrude 20mm of feed stock\nG92 E0                  ;zero the extruded length again\nG1 F7200                ;set feedrate to 120 mm/s\n; -- end of START GCODE --"
        },
        "machine_end_gcode": {
            "default_value": "; -- END GCODE --\nM104 S0                 ;set extruder temperature to zero (turned off)\nG91                     ;set to relative positioning\nG1 E-20 F300            ;retract the filament a bit to release some of the pressure\nG90                     ;set to absolute positioning\nG1 Z200                 ;move the platform to the bottom\nG28 X0 Y0               ;move to the X/Y origin (Home)\nM84                     ;turn off steppers\n; -- end of END GCODE --"
        },
        "machine_width": {
            "default_value": 297
        },
        "machine_depth": {
            "default_value": 210
        },
        "machine_height": {
            "default_value": 200
        },
        "machine_heated_bed": {
            "default_value": false
        },
        "machine_center_is_zero": {
            "default_value": false
        },
        "machine_gcode_flavor": {
            "default_value": "RepRap (Marlin/Sprinter)"
        },
        "layer_height": {
            "default_value": 0.2
        },
        "layer_height_0": {
            "default_value": 0.2
        },
        "wall_thickness": {
            "value": "1"
        },
        "top_bottom_thickness": {
            "default_value": 1
        },
        "speed_print": {
            "default_value": 40
        },
        "support_enable": {
            "default_value": true
        }

    }
}