Cura/resources/quality/ultimaker2_plus_connect/um2pc_nylon_0.4_fast.inst.cfg

[general]
version = 4
name = Normal
definition = ultimaker2_plus_connect

[metadata]
setting_version = 20
type = quality
quality_type = draft
weight = -1
material = generic_nylon
variant = 0.4 mm

[values]
cool_fan_speed_min = =cool_fan_speed * 0.35
cool_min_layer_time = 3
cool_min_speed = 15
infill_overlap = =0 if infill_sparse_density > 80 else 5
infill_sparse_density = 20
layer_0_z_overlap = 0.22
raft_airgap = 0.57
raft_base_line_spacing = 1.6
raft_base_line_width = 0.8
raft_interface_line_spacing = 1
raft_interface_line_width = 0.8
raft_margin = 15
raft_surface_line_width = 0.5
raft_surface_thickness = 0.15
retraction_prime_speed = =retraction_speed
speed_layer_0 = =math.ceil(speed_print * 30 / 45)
speed_print = 45
speed_topbottom = =math.ceil(speed_print * 20 / 45)
speed_travel = 150
speed_wall = =math.ceil(speed_print * 40 / 45)
support_angle = 45
support_enable = True
support_infill_rate = =0 if support_enable and support_structure == 'tree' else 25
support_pattern = lines
support_xy_distance = 0.6
support_z_distance = =layer_height * 2
top_bottom_thickness = 0.75
speed_wall_0 = =math.ceil(speed_print * 30 / 45)
speed_wall_x = =math.ceil(speed_print * 40 / 45)
speed_infill = =math.ceil(speed_print * 45 / 45)