Cura/resources/quality/ultimaker_s5/um_s5_aa0.4_tpu_0.15mm.inst.cfg

[general]
definition = ultimaker_s5
name = Normal
version = 4

[metadata]
material = generic_tpu
quality_type = fast
setting_version = 24
type = quality
variant = AA 0.4
weight = -1

[values]
bridge_skin_material_flow = 200
bridge_skin_speed = =bridge_wall_speed
bridge_sparse_infill_max_density = 50
bridge_wall_material_flow = =bridge_skin_material_flow
bridge_wall_speed = 10
brim_width = 8.75
gradual_infill_step_height = =5 * layer_height
infill_pattern = ='zigzag' if infill_sparse_density > 80 else 'cross_3d'
infill_sparse_density = 10
infill_wipe_dist = 0.1
machine_min_cool_heat_time_window = 15
machine_nozzle_cool_down_speed = 0.5
machine_nozzle_heat_up_speed = 2.5
material_final_print_temperature = =material_print_temperature - 10
material_flow = 106
material_initial_print_temperature = =material_print_temperature - 10
multiple_mesh_overlap = 0
prime_tower_wipe_enabled = True
retraction_count_max = 15
retraction_extra_prime_amount = 0.8
retraction_hop_only_when_collides = True
skin_line_width = =round(line_width / 0.8, 2)
speed_print = 25
speed_topbottom = =math.ceil(speed_print * 0.8)
speed_wall = =math.ceil(speed_print * 25 / 25)
speed_wall_0 = =math.ceil(speed_wall * 25 / 25)
support_angle = 50
support_bottom_distance = =support_z_distance
support_interface_enable = True
support_top_distance = =support_z_distance
support_z_distance = =math.ceil(0.3/layer_height)*layer_height
switch_extruder_prime_speed = 15
switch_extruder_retraction_amount = 20
switch_extruder_retraction_speeds = 35
top_bottom_thickness = =layer_height * 6
travel_avoid_distance = 1.5
wall_0_inset = 0