Cura/resources/quality/ultimaker2_plus/um2p_cpep_0.6_normal.inst.cfg

[general]
version = 4
name = Fine
definition = ultimaker2_plus

[metadata]
setting_version = 11
type = quality
quality_type = draft
weight = 0
material = generic_cpe_plus
variant = 0.6 mm

[values]
adhesion_type = raft
cool_fan_speed = 45
cool_fan_speed_min = =cool_fan_speed * 25 / 45
cool_min_layer_time = 3
cool_min_speed = 8
infill_overlap = 5
infill_sparse_density = 35
layer_0_z_overlap = 0.22
line_width = 0.57
raft_airgap = 0.37
raft_base_line_spacing = 2.4
raft_base_line_width = 1.2
raft_interface_line_spacing = 1.4
raft_interface_line_width = 1.2
raft_margin = 15
raft_surface_line_width = 0.57
raft_surface_thickness = 0.2
speed_layer_0 = =math.ceil(speed_print * 30 / 35)
speed_print = 35
speed_topbottom = =math.ceil(speed_print * 20 / 35)
speed_travel = 150
speed_wall_0 = =math.ceil(speed_print * 30 / 35)
speed_wall_x = =speed_print
support_angle = 45
support_enable = True
support_infill_rate = =20 if support_enable else 0 if support_tree_enable else 20
support_line_distance = 2.85
support_pattern = lines
support_xy_distance = 0.6
support_z_distance = 0.22
top_bottom_thickness = 0.75
wall_thickness = 1.14