Cura/resources/quality/ultimaker2_plus/um2p_cpep_0.4_draft.inst.cfg

[general]
version = 4
name = Fast
definition = ultimaker2_plus

[metadata]
setting_version = 11
type = quality
quality_type = draft
weight = -2
material = generic_cpe_plus
variant = 0.4 mm

[values]
adhesion_type = raft
cool_fan_speed = 50
cool_fan_speed_min = =cool_fan_speed * 25 / 50
cool_min_layer_time = 3
cool_min_speed = 8
infill_overlap = 5
infill_sparse_density = 30
layer_0_z_overlap = 0.22
line_width = 0.38
raft_airgap = 0.37
raft_base_line_spacing = 1.6
raft_base_line_width = 0.8
raft_interface_line_spacing = 1
raft_interface_line_width = 0.8
raft_margin = 15
raft_surface_line_width = 0.38
speed_layer_0 = =math.ceil(speed_print * 15 / 25)
speed_print = 25
speed_topbottom = =math.ceil(speed_print * 20 / 25)
speed_wall_0 = =math.ceil(speed_print * 20 / 25)
speed_wall_x = =speed_print
support_angle = 45
support_enable = True
support_infill_rate = =20 if support_enable else 0 if support_tree_enable else 20
support_pattern = lines
support_z_distance = 0.26
top_bottom_thickness = 1.5
wall_thickness = 1.14