Cura/resources/variants/cartesio_0.4.inst.cfg

[general]
name = 0.4 mm
version = 2
definition = cartesio

[metadata]
author = Cartesio
type = variant

[values]
machine_nozzle_size = 0.4
machine_nozzle_tip_outer_diameter = 0.8

infill_line_width = 0.5

wall_thickness = 1.2
top_bottom_thickness = 0.8
wall_0_inset = -0.05
fill_perimeter_gaps = nowhere
travel_compensate_overlapping_walls_enabled =

infill_sparse_density = 40
infill_pattern = grid

material_print_temperature_layer_0 = =round(material_print_temperature)
material_initial_print_temperature = =round(material_print_temperature)
material_diameter = 1.75
retraction_amount = 1
retraction_prime_speed = =round(retraction_speed / 5)
retraction_min_travel = =round(line_width * 10)
switch_extruder_retraction_amount = 2
switch_extruder_retraction_speeds = =round(retraction_speed)
switch_extruder_prime_speed = =round(retraction_prime_speed)

speed_print = 50
speed_infill = =round(speed_print)
speed_layer_0 = =round(speed_print / 5 * 4)
speed_wall = =round(speed_print / 2)
speed_wall_0 = =10 if speed_wall < 11 else (speed_print / 5 *3)
speed_topbottom = =round(speed_print / 5 * 4)
speed_slowdown_layers = 1
speed_travel = =round(speed_print if magic_spiralize else 150)
speed_travel_layer_0 = =round(speed_travel)
speed_support_interface = =round(speed_topbottom)

retraction_combing = off
retraction_hop_enabled = True
retraction_hop = 1

cool_min_layer_time_fan_speed_max = =round(cool_min_layer_time)
cool_min_layer_time = 20

support_z_distance = 0
support_xy_distance = 0.5
support_join_distance = 10
support_interface_enable = True

adhesion_type = skirt
skirt_gap = 0.5
skirt_brim_minimal_length = 50

coasting_enable = True
coasting_volume = 0.1
coasting_min_volume = 0.17
coasting_speed = 90