Cura/resources/variants/ultimaker3_extended_aa04.inst.cfg

[general]
definition = ultimaker3_extended
name = AA 0.4
version = 4

[metadata]
hardware_type = nozzle
setting_version = 22
type = variant

[values]
brim_width = 7
machine_nozzle_cool_down_speed = 0.9
machine_nozzle_id = AA 0.4
machine_nozzle_tip_outer_diameter = 1.0
retraction_amount = 6.5
retraction_min_travel = =line_width * 2
retraction_prime_speed = =retraction_speed
skin_overlap = 15
speed_print = 70
speed_topbottom = =math.ceil(speed_print * 30 / 70)
speed_wall = =math.ceil(speed_print * 30 / 70)
support_angle = 60
support_bottom_distance = =support_z_distance / 2
support_top_distance = =support_z_distance
support_z_distance = =layer_height * 2
switch_extruder_prime_speed = =switch_extruder_retraction_speeds
switch_extruder_retraction_amount = =machine_heat_zone_length
top_bottom_thickness = 1.2
xy_offset_layer_0 = =(-0.2 if adhesion_type == "skirt" or adhesion_type == "none" else 0) + xy_offset