Cura/resources/quality/nps/nps_PC_B.inst.cfg

[general]
definition = nps
name = B
version = 4

[metadata]
material = generic_pc
quality_type = b
setting_version = 22
type = quality
weight = 0

[values]
adhesion_type = brim
bridge_fan_speed = 100
bridge_settings_enabled = True
bridge_skin_density = 80
bridge_skin_material_flow = 100
bridge_skin_speed = 12.5
bridge_wall_coast = 50
bridge_wall_material_flow = 50
bridge_wall_speed = 12
cool_fan_enabled = True
cool_fan_full_at_height = =layer_height_0 + 2 * layer_height
cool_fan_speed = 10
cool_fan_speed_max = 10
cool_lift_head = true
cool_min_layer_time = 2
cool_min_layer_time_fan_speed_max = 20
cool_min_speed = 12
material_bed_temperature = 110
material_flow = 88
material_print_temperature = =default_material_print_temperature
material_print_temperature_layer_0 = 275
prime_tower_enable = True
retraction_extra_prime_amount = 0.1
retraction_hop_only_when_collides = True
retraction_min_travel = =3*line_width
retraction_speed = 30
skin_overlap = 15
speed_layer_0 = =math.ceil(speed_print * 25/55)
speed_print = 35
speed_slowdown_layers = 2
speed_topbottom = =math.ceil(speed_print * 37/55)
speed_wall = =math.ceil(speed_print * 37/55)
speed_wall_0 = =math.ceil(speed_wall * 33/37)
support_angle = 60
support_bottom_distance = =support_z_distance*0.5
support_interface_density = 100
support_offset = 1
support_xy_distance = =line_width * 1.7
support_xy_distance_overhang = =wall_line_width_0
support_z_distance = =layer_height
wall_line_count = 3