ultimaker3_extended_aa0.25.inst.cfg 1.4 KB

1234567891011121314151617181920212223242526272829303132333435363738394041424344
  1. [general]
  2. name = AA 0.25
  3. version = 4
  4. definition = ultimaker3_extended
  5. [metadata]
  6. setting_version = 20
  7. type = variant
  8. hardware_type = nozzle
  9. [values]
  10. brim_width = 7
  11. layer_height_0 = 0.17
  12. machine_nozzle_cool_down_speed = 0.85
  13. machine_nozzle_heat_up_speed = 1.5
  14. machine_nozzle_id = AA 0.25
  15. machine_nozzle_size = 0.25
  16. machine_nozzle_tip_outer_diameter = 0.65
  17. material_final_print_temperature = =material_print_temperature - 10
  18. material_initial_print_temperature = =material_print_temperature - 5
  19. raft_airgap = 0.3
  20. raft_base_thickness = =resolveOrValue('layer_height_0') * 1.2
  21. raft_interface_line_spacing = =raft_interface_line_width + 0.2
  22. raft_interface_line_width = =line_width * 2
  23. raft_interface_thickness = =layer_height * 1.5
  24. raft_jerk = =jerk_print
  25. raft_margin = 15
  26. raft_surface_layers = 2
  27. retraction_min_travel = 0.7
  28. retraction_prime_speed = =retraction_speed
  29. skin_overlap = 15
  30. speed_layer_0 = 20
  31. speed_print = 55
  32. speed_topbottom = 20
  33. speed_wall = =math.ceil(speed_print * 30 / 55)
  34. support_angle = 60
  35. support_bottom_distance = =support_z_distance / 2
  36. support_top_distance = =support_z_distance
  37. support_z_distance = =layer_height * 2
  38. switch_extruder_prime_speed = =switch_extruder_retraction_speeds
  39. switch_extruder_retraction_amount = =machine_heat_zone_length
  40. top_bottom_thickness = 1.2
  41. wall_thickness = =wall_line_width_0 + wall_line_width_x * 2
  42. xy_offset_layer_0 = =(-0.2 if adhesion_type == "skirt" or adhesion_type == "none" else 0) + xy_offset