Cura/resources/quality/ultimaker2_plus_connect/um2pc_nylon_0.6_fast.inst.cfg

[general]
version = 4
name = Normal
definition = ultimaker2_plus_connect

[metadata]
setting_version = 20
type = quality
quality_type = slightlycoarse
weight = -1
material = generic_nylon
variant = 0.6 mm

[values]
brim_line_count = 8
cool_fan_speed_min = =cool_fan_speed * 0.35
cool_min_speed = 15
infill_overlap = =0 if infill_sparse_density > 80 else 5
infill_sparse_density = 20
layer_0_z_overlap = 0.22
raft_airgap = 0.44
raft_base_line_spacing = 2.4
raft_base_line_width = 1.2
raft_interface_line_spacing = 1.4
raft_interface_line_width = 1.2
raft_margin = 15
raft_surface_line_width = 0.6
raft_surface_thickness = 0.15
retraction_hop_enabled = 0.2
retraction_prime_speed = =retraction_speed
speed_layer_0 = =math.ceil(speed_print * 30 / 55)
speed_print = 55
speed_support = 40
speed_topbottom = =math.ceil(speed_print * 35 / 55)
speed_travel = 150
speed_wall_0 = =math.ceil(speed_print * 15 / 55)
speed_wall_x = =math.ceil(speed_print * 40 / 55)
support_angle = 45
support_enable = True
support_z_distance = 0.55
top_bottom_thickness = 1.2
speed_infill = =math.ceil(speed_print * 55 / 55)