| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354 |
- [general]
- version = 4
- name = Extra Fine
- definition = ultimaker_s3
- [metadata]
- setting_version = 20
- type = quality
- quality_type = high
- weight = 1
- material = generic_pc
- variant = AA 0.4
- [values]
- adhesion_type = brim
- brim_width = 20
- cool_fan_full_at_height = =layer_height_0 + layer_height
- cool_fan_speed_max = 50
- cool_min_layer_time_fan_speed_max = 5
- cool_min_speed = 8
- infill_overlap = 0
- infill_overlap_mm = =0 if infill_sparse_density > 80 else 0.05
- infill_pattern = ='zigzag' if infill_sparse_density > 80 else 'triangles'
- infill_wipe_dist = 0.1
- jerk_enabled = True
- jerk_print = 25
- machine_min_cool_heat_time_window = 15
- machine_nozzle_cool_down_speed = 0.85
- machine_nozzle_heat_up_speed = 1.5
- material_final_print_temperature = =material_print_temperature - 10
- material_initial_print_temperature = =material_print_temperature - 5
- material_print_temperature = =default_material_print_temperature - 10
- material_standby_temperature = 100
- multiple_mesh_overlap = 0
- ooze_shield_angle = 40
- prime_tower_enable = True
- prime_tower_wipe_enabled = True
- raft_airgap = 0.25
- raft_interface_thickness = =max(layer_height * 1.5, 0.225)
- retraction_hop = 2
- retraction_hop_only_when_collides = True
- retraction_min_travel = 0.8
- skin_overlap = 30
- speed_layer_0 = =math.ceil(speed_print * 25 / 50)
- speed_print = 50
- speed_topbottom = =math.ceil(speed_print * 25 / 50)
- speed_wall = =math.ceil(speed_print * 40 / 50)
- speed_wall_0 = =math.ceil(speed_wall * 25 / 40)
- support_interface_density = 87.5
- switch_extruder_prime_speed = 15
- switch_extruder_retraction_amount = 20
- switch_extruder_retraction_speeds = 35
- wall_0_inset = 0
|
