Cura/resources/quality/nps/nps_PETG_A.inst.cfg

[general]
version = 4
name = A
definition = nps

[metadata]
setting_version = 20
type = quality
quality_type = a
weight = 1
material = generic_petg

[values]
speed_print = 50
speed_wall = =math.ceil(speed_print * 35/50)
speed_wall_0 = =math.ceil(speed_wall * 30/35)
speed_topbottom = =math.ceil(speed_print * 35/50)
speed_layer_0 = =math.ceil(speed_print * 20/50)
speed_slowdown_layers = 2
cool_fan_enabled = True
cool_fan_speed = 50
cool_fan_speed_max = 100
cool_min_layer_time_fan_speed_max = 20
cool_min_layer_time = 11
cool_fan_full_at_height = =layer_height_0 + 3 * layer_height
cool_min_speed = 10
support_angle = 65
material_print_temperature = =default_material_print_temperature + 20
material_print_temperature_layer_0 = =230
material_bed_temperature = 80
material_flow = 98
retraction_extra_prime_amount = 0
retraction_min_travel = =3*line_width
retraction_hop_only_when_collides = True
skin_overlap = 10
support_z_distance = =layer_height*2
support_bottom_distance = =support_z_distance*0.5
support_xy_distance = =line_width * 1.7
support_xy_distance_overhang = =wall_line_width_0
support_offset = 1
support_interface_density = 100
prime_tower_enable = True