um2p_nylon_0.6_normal.inst.cfg 1.1 KB

12345678910111213141516171819202122232425262728293031323334353637383940414243444546
  1. [general]
  2. version = 4
  3. name = Fine
  4. definition = ultimaker2_plus
  5. [metadata]
  6. setting_version = 5
  7. type = quality
  8. quality_type = normal
  9. weight = 0
  10. material = generic_nylon
  11. variant = 0.6 mm
  12. [values]
  13. adhesion_type = raft
  14. brim_line_count = 8
  15. cool_fan_speed_min = =cool_fan_speed * 0.35
  16. cool_min_speed = 15
  17. infill_overlap = 5
  18. infill_sparse_density = 35
  19. layer_0_z_overlap = 0.22
  20. layer_height = 0.15
  21. raft_airgap = 0.44
  22. raft_base_line_spacing = 2.4
  23. raft_base_line_width = 1.2
  24. raft_interface_line_spacing = 1.4
  25. raft_interface_line_width = 1.2
  26. raft_margin = 15
  27. raft_surface_line_width = 0.6
  28. raft_surface_thickness = 0.15
  29. retraction_hop_enabled = 0.2
  30. speed_layer_0 = =math.ceil(speed_print * 30 / 55)
  31. speed_print = 55
  32. speed_support = 40
  33. speed_topbottom = =math.ceil(speed_print * 35 / 55)
  34. speed_travel = 150
  35. speed_wall_0 = =math.ceil(speed_print * 15 / 55)
  36. speed_wall_x = =math.ceil(speed_print * 40 / 55)
  37. support_angle = 45
  38. support_enable = True
  39. support_infill_rate = 25
  40. support_pattern = lines
  41. support_xy_distance = 0.7
  42. support_z_distance = =layer_height * 2
  43. top_bottom_thickness = 1.2
  44. wall_thickness = 1.2