| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768 |
- [general]
- definition = ultimaker_method
- name = Fast
- version = 4
- [metadata]
- material = ultimaker_petg_175
- quality_type = draft
- setting_version = 24
- type = quality
- variant = 1A
- weight = -2
- [values]
- cool_fan_enabled = True
- cool_fan_speed = 50
- cool_fan_speed_0 = 0
- cool_fan_speed_max = 100
- cool_min_layer_time = 10
- cool_min_speed = 5
- initial_layer_line_width_factor = 150
- min_bead_width = =line_width * 0.75
- min_wall_line_width = =line_width * 0.75
- raft_airgap = 0.2
- raft_base_infill_overlap = 10
- raft_base_line_spacing = =4 if extruder_nr == raft_interface_extruder_nr else 2.8
- raft_base_line_width = =1.2 if extruder_nr == raft_interface_extruder_nr else 1.4
- raft_base_thickness = 0.6
- raft_interface_infill_overlap = 35
- raft_interface_layers = 1
- raft_interface_line_spacing = 0.75
- raft_interface_speed = 40
- raft_interface_thickness = 0.2
- raft_speed = 15
- raft_surface_infill_overlap = 25
- raft_surface_line_spacing = 0.425
- raft_surface_line_width = 0.4
- raft_surface_speed = 40
- skin_overlap = 10
- speed_layer_0 = 15
- speed_print = 60
- speed_roofing = =speed_print / 3
- speed_support = =speed_print
- speed_support_interface = 40
- speed_topbottom = =speed_print * 0.6
- speed_wall = =speed_print / 6
- speed_wall_0 = =speed_wall
- speed_wall_x = =speed_wall
- support_angle = 50.0
- support_bottom_distance = =layer_height
- support_bottom_enable = False
- support_infill_angles = [45 ]
- support_infill_rate = 12
- support_interface_density = 83
- support_interface_height = =layer_height * 4
- support_interface_material_flow = =material_flow
- support_line_width = =line_width * 0.75
- support_material_flow = =material_flow
- support_offset = 3
- support_roof_density = =support_interface_density
- support_roof_line_width = =line_width
- support_supported_skin_fan_speed = =cool_fan_speed if support_wall_count > 0 else cool_fan_speed_max
- support_top_distance = =support_z_distance
- support_xy_distance = 0.3
- support_xy_overrides_z = xy_overrides_z
- support_z_distance = 0.2
- switch_extruder_retraction_amount = 1
|
