Cura/resources/quality/ultimaker_s3/um_s3_aa0.25_pc_0.1mm.inst.cfg

[general]
definition = ultimaker_s3
name = Fine - Experimental
version = 4

[metadata]
is_experimental = True
material = generic_pc
quality_type = normal
setting_version = 24
type = quality
variant = AA 0.25
weight = 0

[values]
brim_width = 20
infill_pattern = ='zigzag' if infill_sparse_density > 80 else 'triangles'
infill_wipe_dist = 0.1
machine_min_cool_heat_time_window = 15
material_print_temperature = =default_material_print_temperature - 10
multiple_mesh_overlap = 0
ooze_shield_angle = 40
prime_tower_enable = True
prime_tower_wipe_enabled = True
raft_airgap = 0.25
retraction_hop = 2
retraction_hop_only_when_collides = True
speed_print = 50
speed_topbottom = =math.ceil(speed_print * 25 / 50)
speed_wall = =math.ceil(speed_print * 40 / 50)
speed_wall_0 = =math.ceil(speed_wall * 25 / 40)
support_bottom_distance = =support_z_distance
support_interface_density = 87.5
support_interface_enable = True
support_top_distance = =support_z_distance
support_z_distance = =math.ceil(0.3/layer_height)*layer_height
switch_extruder_prime_speed = 15
switch_extruder_retraction_amount = 20
switch_extruder_retraction_speeds = 35
wall_0_inset = 0