| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869 |
- [general]
- definition = ultimaker_methodxl
- name = Fast
- version = 4
- [metadata]
- material = ultimaker_pva_175
- quality_type = draft
- setting_version = 24
- type = quality
- variant = 2A
- weight = -2
- [values]
- brim_replaces_support = False
- cool_fan_enabled = False
- cool_min_speed = 5
- cool_min_temperature = =material_print_temperature
- initial_layer_line_width_factor = 300
- material_final_print_temperature = =default_material_print_temperature
- material_initial_print_temperature = =default_material_print_temperature
- prime_tower_flow = 125
- raft_airgap = 0.0
- raft_interface_flow = 110
- raft_interface_infill_overlap = 50
- raft_interface_layers = 1
- raft_interface_line_spacing = =1.08 if raft_base_thickness == 0.5 else 0.9
- raft_interface_line_width = =1.2 if raft_base_thickness == 0.5 else 1
- raft_interface_speed = =speed_print * 3/10
- raft_interface_z_offset = =-0.1 if raft_base_thickness == 0.5 else -0.05
- raft_surface_flow = 110
- raft_surface_infill_overlap = 50
- raft_surface_line_spacing = 0.44
- raft_surface_speed = =speed_print * 2/5
- raft_surface_thickness = 0.27
- raft_surface_z_offset = -0.075
- retraction_min_travel = 5
- retraction_speed = 1.75
- speed_layer_0 = =speed_print * 1/5
- speed_prime_tower = =speed_print * 1/5
- speed_print = 50
- speed_roofing = =speed_print
- speed_support = =speed_print
- speed_support_bottom = =speed_print * 1/5
- speed_support_interface = =speed_print
- speed_topbottom = =speed_print
- speed_wall_0 = =speed_print
- speed_wall_x = =speed_print
- support_angle = 50
- support_bottom_density = 99
- support_bottom_line_width = 1.2
- support_bottom_wall_count = =support_wall_count
- support_conical_angle = 20
- support_conical_enabled = True
- support_conical_min_width = 20
- support_fan_enable = False
- support_infill_density_multiplier_initial_layer = 2
- support_infill_rate = 12
- support_interface_offset = 0
- support_interface_wall_count = 2
- support_offset = 1.8
- support_pattern = zigzag
- support_roof_density = 95
- support_roof_height = =layer_height*8
- support_roof_line_width = 0.4
- switch_extruder_extra_prime_amount = 1
- switch_extruder_retraction_amount = 2.5
- switch_extruder_retraction_speeds = 3
|
