| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667 |
- [general]
- definition = ultimaker_methodx
- name = Fast - Experimental
- version = 4
- [metadata]
- is_experimental = True
- material = ultimaker_asa_175
- quality_type = draft
- setting_version = 23
- type = quality
- variant = 1XA
- weight = -2
- [values]
- cool_fan_enabled = =True if extruder_nr == support_extruder_nr else False
- cool_fan_full_layer = 3
- cool_fan_speed = 85.0
- cool_fan_speed_0 = 0
- cool_fan_speed_max = 100
- cool_min_layer_time = 10
- cool_min_layer_time_fan_speed_max = 15
- cool_min_speed = =round(speed_wall_0 * 3 / 4) if cool_lift_head else round(speed_wall_0 / 5)
- material_print_temperature_layer_0 = =default_material_print_temperature+5
- raft_airgap = =0.15 if extruder_nr == support_extruder_nr else 0
- raft_base_speed = 10
- raft_base_thickness = =0.6 if extruder_nr == support_extruder_nr else 0.8
- raft_surface_speed = 90
- retraction_amount = 0.5
- retraction_min_travel = 3.2
- skin_overlap = 10
- small_skin_width = 3.6
- speed_layer_0 = 35
- speed_prime_tower = 30.0
- speed_print = 120.0
- speed_roofing = 65
- speed_support = 100
- speed_support_interface = 75
- speed_topbottom = 55
- speed_travel = 250.0
- speed_wall = 25
- speed_wall_0 = 20
- speed_wall_x = 25
- support_angle = 50
- support_bottom_density = 24
- support_bottom_line_width = 0.6
- support_bottom_stair_step_height = 0
- support_infill_angles = [45,45,45,45,45,45,45,45,45,45,135,135,135,135,135,135,135,135,135,135]
- support_infill_rate = 15.0
- support_interface_enable = True
- support_interface_pattern = lines
- support_line_width = 0.3
- support_material_flow = =0.85*material_flow
- support_roof_density = 85
- support_roof_line_width = =0.4 if extruder_nr == support_extruder_nr else 0.25
- support_roof_wall_count = 1
- support_supported_skin_fan_speed = 60.0
- support_top_distance = =support_z_distance
- support_use_towers = False
- support_xy_distance = 0.35
- support_xy_distance_overhang = 0.25
- support_xy_overrides_z = xy_overrides_z
- support_z_distance = 0.15
- top_skin_expand_distance = 2.4
- wall_overhang_angle = 30
- wall_overhang_speed_factor = 40
|
