| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051 |
- [general]
- name = BB 0.4
- version = 4
- definition = ultimaker_s3
- [metadata]
- setting_version = 9
- type = variant
- hardware_type = nozzle
- [values]
- acceleration_support = =math.ceil(acceleration_print * 2000 / 4000)
- acceleration_support_interface = =math.ceil(acceleration_support * 1500 / 2000)
- acceleration_support_bottom = =math.ceil(acceleration_support_interface * 100 / 1500)
- acceleration_prime_tower = =math.ceil(acceleration_print * 200 / 4000)
- cool_fan_speed_max = =cool_fan_speed
- gradual_support_infill_steps = 2
- jerk_prime_tower = =math.ceil(jerk_print * 2 / 25)
- jerk_support = =math.ceil(jerk_print * 15 / 25)
- jerk_support_interface = =math.ceil(jerk_support * 10 / 15)
- jerk_support_bottom = =math.ceil(jerk_support_interface * 1 / 10)
- machine_nozzle_heat_up_speed = 1.5
- machine_nozzle_id = BB 0.4
- machine_nozzle_tip_outer_diameter = 1.0
- raft_base_speed = 20
- raft_interface_speed = 20
- raft_speed = 25
- retraction_amount = 4.5
- retraction_count_max = 20
- retraction_extrusion_window = =retraction_amount
- retraction_min_travel = =3 * line_width
- speed_layer_0 = 20
- speed_prime_tower = =math.ceil(speed_print * 10 / 35)
- speed_support = =math.ceil(speed_print * 25 / 35)
- speed_support_interface = =math.ceil(speed_support * 20 / 25)
- speed_support_bottom = =math.ceil(speed_support_interface * 10 / 20)
- speed_wall_0 = =math.ceil(speed_wall * 25 / 30)
- support_bottom_height = =layer_height * 2
- support_bottom_pattern = zigzag
- support_bottom_stair_step_height = =layer_height
- support_infill_rate = 50
- support_infill_sparse_thickness = 0.2
- support_interface_enable = True
- support_interface_height = 0.6
- support_interface_skip_height = =layer_height
- support_join_distance = 3
- support_line_width = =round(line_width * 0.4 / 0.35, 2)
- support_offset = 3
- support_xy_distance = =round(wall_line_width_0 * 0.75, 2)
- support_xy_distance_overhang = =wall_line_width_0 / 2
- switch_extruder_retraction_amount = 12
|
