Cura/resources/quality/ultimaker2_plus/um2p_nylon_0.25_normal.inst.cfg

[general]
version = 4
name = Fine
definition = ultimaker2_plus

[metadata]
setting_version = 9
type = quality
quality_type = normal
weight = 0
material = generic_nylon
variant = 0.25 mm

[values]
adhesion_type = raft
brim_line_count = 8
cool_fan_speed = 60
cool_fan_speed_min = =cool_fan_speed * 35 / 60
cool_min_speed = 15
infill_overlap = 5
infill_sparse_density = 25
layer_0_z_overlap = 0.1
raft_airgap = 0.15
raft_base_line_width = 0.5
raft_interface_line_spacing = 0.7
raft_interface_line_width = 0.5
raft_margin = 15
raft_surface_line_width = 0.2
retraction_hop_enabled = 0.2
speed_layer_0 = =math.ceil(speed_print * 30 / 40)
speed_print = 40
speed_support = 40
speed_topbottom = =math.ceil(speed_print * 35 / 40)
speed_travel = 150
speed_wall_0 = =math.ceil(speed_print * 20 / 40)
speed_wall_x = =speed_print
support_enable = True
support_infill_rate = =20 if support_enable else 0 if support_tree_enable else 20
support_pattern = lines
support_xy_distance = 0.6
support_z_distance = =layer_height * 2
top_bottom_thickness = 1.2
wall_thickness = 1