Cura/resources/quality/ultimaker2_plus/um2p_nylon_0.6_normal.inst.cfg

[general]
version = 4
name = Fine
definition = ultimaker2_plus

[metadata]
setting_version = 4
type = quality
quality_type = normal
weight = 0
material = generic_nylon
variant = 0.6 mm

[values]
adhesion_type = raft
brim_line_count = 8
cool_fan_speed_min = =cool_fan_speed * 0.35
cool_min_speed = 15
infill_overlap = 5
infill_sparse_density = 35
layer_0_z_overlap = 0.22
layer_height = 0.15
raft_airgap = 0.44
raft_base_line_spacing = 2.4
raft_base_line_width = 1.2
raft_interface_line_spacing = 1.4
raft_interface_line_width = 1.2
raft_margin = 15
raft_surface_line_width = 0.6
raft_surface_thickness = 0.15
retraction_hop_enabled = 0.2
speed_layer_0 = 30
speed_print = 55
speed_support = 40
speed_topbottom = 35
speed_travel = 150
speed_wall_0 = 15
speed_wall_x = 40
support_angle = 45
support_enable = True
support_infill_rate = 25
support_pattern = lines
support_xy_distance = 0.7
support_z_distance = =layer_height * 2
top_bottom_thickness = 1.2
wall_thickness = 1.2