Cura/resources/quality/ultimaker_s3/um_s3_aa0.4_nylon_0.1mm.inst.cfg

[general]
definition = ultimaker_s3
name = Fine
version = 4

[metadata]
material = generic_nylon
quality_type = normal
setting_version = 22
type = quality
variant = AA 0.4
weight = 0

[values]
ooze_shield_angle = 40
raft_airgap = 0.4
support_bottom_distance = =support_z_distance
support_interface_enable = True
support_top_distance = =support_z_distance
support_z_distance = =math.ceil(0.3/layer_height)*layer_height
switch_extruder_prime_speed = 30
switch_extruder_retraction_amount = 30
switch_extruder_retraction_speeds = 40