Cura/resources/intent/ultimaker_methodxl/um_methodxl_labs_um-tough-pla-175_0.2mm_highspeedsolid.inst.cfg

[general]
definition = ultimaker_methodxl
name = High Speed Solid
version = 4

[metadata]
intent_category = highspeedsolid
is_experimental = True
material = ultimaker_tough_pla_175
quality_type = draft
setting_version = 24
type = intent
variant = LABS

[values]
acceleration_print = 3500
bottom_thickness = =top_bottom_thickness
bridge_wall_speed = 300
build_volume_temperature = 45
cool_fan_enabled = True
cool_fan_speed = 100
cool_min_layer_time = 3
infill_angles = [45,135]
infill_material_flow = 97
infill_pattern = zigzag
infill_sparse_density = 99
jerk_print = 35
material_bed_temperature = 45
speed_infill = 240.0
speed_layer_0 = 55
speed_print = 300
speed_travel = 500
speed_travel_layer_0 = 350.0
speed_wall_0 = 45
support_interface_line_width = 0.42
support_line_width = 0.47
support_material_flow = 100
support_pattern = zigzag
support_roof_line_width = 0.42
top_bottom_thickness = =layer_height * 2
top_thickness = =top_bottom_thickness