Cura/resources/quality/snapmaker2/snapmaker2_normal.inst.cfg

[general]
version = 4
name = Normal
definition = snapmaker2

[metadata]
setting_version = 20
type = quality
quality_type = normal
weight = 0
global_quality = True

[values]
layer_height = 0.16
layer_height_0 = 0.2
initial_layer_line_width_factor = 100

wall_thickness = 1.2
wall_line_count = 3
top_thickness = 0.8
top_layers = 5
bottom_thickness = 0.8
bottom_layers = 5
inset_direction = inside_out
skin_outline_count = 0

; infill_line_distance = 8
infill_sparse_density = 15
infill_sparse_thickness = 0.16
skin_preshrink = 1.2
top_skin_preshrink = 1.2
bottom_skin_preshrink = 1.2
expand_skins_expand_distance = 1.2
top_skin_expand_distance = 1.2
bottom_skin_expand_distance = 1.2

speed_travel = 70
speed_topbottom = 25
speed_wall_x = 20
speed_wall_0 = 15
speed_wall = 30
speed_infill = 50
speed_print = 50
speed_print_layer_0 = 18
speed_travel_layer_0 = 24
skirt_brim_speed = 18

retraction_hop = 1
retraction_hop_enabled = False

magic_spiralize = False
magic_mesh_surface_mode = normal

adhesion_type = skirt
skirt_line_count = 1
brim_width = 8
brim_line_count = 20
raft_margin = 15

support_enable = False
support_type = everywhere
support_pattern = zigzag
support_angle = 50
support_infill_rate = 15
support_line_distance = 2.66
support_initial_layer_line_distance = 2.66