[general]
version = 4
name = Extra Fine
definition = ultimaker2_plus

[metadata]
setting_version = 20
type = quality
quality_type = high
weight = 1
material = generic_tpu
variant = 0.25 mm

[values]
adhesion_type = brim
brim_line_count = 8
cool_fan_speed = 60
cool_fan_speed_min = =cool_fan_speed * 35 / 60
cool_min_layer_time = 7
cool_min_speed = 15
infill_sparse_density = 10
layer_0_z_overlap = 0.1
raft_airgap = 0.2
raft_base_line_spacing = 1
raft_interface_line_spacing = 1
raft_interface_line_width = 0.2
raft_surface_line_width = 0.2
retraction_hop_enabled = 0.2
speed_layer_0 = =math.ceil(speed_print * 30 / 40)
speed_print = 40
speed_support = 40
speed_topbottom = =math.ceil(speed_print * 35 / 40)
speed_travel = 150
speed_wall_0 = =math.ceil(speed_print * 15 / 40)
speed_wall_x = =math.ceil(speed_print * 38 / 40)
support_angle = 45
support_enable = True
support_infill_rate = =25 if support_enable and support_structure == 'normal' else 0 if support_enable and support_structure == 'tree' else 25
support_xy_distance = 0.6
support_z_distance = =layer_height * 2
top_bottom_thickness = 1.2
speed_infill = =math.ceil(speed_print * 40 / 40)