{
    "name": "EasyArts Ares",
    "version": 2,
    "inherits": "fdmprinter",
    "metadata": {
        "visible": true,
        "author": "nliaudat",
        "manufacturer": "EasyArts",
        "file_formats": "text/x-gcode",
        "machine_extruder_trains":
        {
            "0": "easyarts_ares_extruder_0"
        }
    },
    "overrides": {
        "machine_start_gcode": {
           "default_value": "; -- START GCODE --\nG21        ;metric values\nG90        ;absolute positioning\nM82        ;set extruder to absolute mode\nM107       ;start with the fan off\nG28        \nG29 Z0.12   ;Auto-bedleveling with Z offset        \nG92 E0                  ;zero the extruded length        \nG1 F2000 E3              ;extrude 3mm of feed stock\nG92 E0                  ;zero the extruded length again\nG1 F{speed_travel}\nM117 Printing...\n; -- end of START GCODE --"
         },
        "machine_end_gcode": {
            "default_value": "; -- START GCODE --\nG28     ; Home all axes\nM104 S0        ;extruder heater off\n;M140 S0        ;heated bed heater off (if you have it)\nG91                       ;relative positioning\nG1 E-1 F300               ;retract the filament a bit before lifting the nozzle, to release some of the pressure\n;M84            ;steppers off\nG90            ;absolute positioning\n; -- end of START GCODE --"
        },
        "machine_width": {
            "default_value": 180
        },
        "machine_depth": {
            "default_value": 180
        },
        "machine_height": {
            "default_value": 200
        },
        "machine_heated_bed": {
            "default_value": false
        },
        "machine_center_is_zero": {
            "default_value": true
        },
        "machine_gcode_flavor": {
            "default_value": "RepRap"
        },
        "layer_height": {
            "default_value": 0.2
        },
        "layer_height_0": {
            "default_value": 0.2
        },
        "wall_thickness": {
            "default_value": 1
        },
        "top_bottom_thickness": {
            "default_value": 1
        },
        "speed_print": {
            "default_value": 75
        },
        "support_enable": {
            "default_value": true
        }
    }
}