[general]
version = 4
name = Normal
definition = ultimaker2_plus_connect

[metadata]
setting_version = 17
type = quality
quality_type = fast
weight = -1
material = generic_tpu
variant = 0.6 mm

[values]
adhesion_type = brim
brim_line_count = 20
cool_fan_speed = 80
cool_fan_speed_min = =cool_fan_speed
cool_min_speed = 15
infill_sparse_density = 10
layer_0_z_overlap = 0.12
line_width = 0.57
raft_airgap = 0.24
raft_base_line_spacing = 1.2
raft_base_line_width = 0.6
raft_interface_line_spacing = 1.2
raft_interface_line_width = 0.57
raft_margin = 15
raft_surface_line_width = 0.5
retraction_hop_enabled = 0.2
speed_layer_0 = =math.ceil(speed_print * 30 / 45)
speed_print = 45
speed_support = 40
speed_topbottom = =math.ceil(speed_print * 35 / 45)
speed_travel = 150
speed_wall_0 = =math.ceil(speed_print * 15 / 45)
speed_wall_x = =math.ceil(speed_print * 40 / 45)
support_angle = 45
support_enable = True
support_infill_rate = =0 if support_structure == 'tree' else 25
support_xy_distance = 0.7
support_z_distance = =layer_height * 2
top_bottom_thickness = 1.2
wall_thickness = 1.14
speed_infill = =math.ceil(speed_print * 45 / 45)