[general]
definition = ultimaker_method
name = Fast
version = 4

[metadata]
material = ultimaker_pva_175
quality_type = draft
setting_version = 24
type = quality
variant = 2A
weight = -2

[values]
brim_replaces_support = False
cool_fan_enabled = False
cool_min_speed = 5
cool_min_temperature = =material_print_temperature
initial_layer_line_width_factor = 300
material_final_print_temperature = =default_material_print_temperature
material_initial_print_temperature = =default_material_print_temperature
prime_tower_flow = 125
raft_airgap = 0.0
raft_interface_flow = 110
raft_interface_infill_overlap = 50
raft_interface_layers = 1
raft_interface_line_spacing = =1.08 if raft_base_thickness == 0.5 else 0.9
raft_interface_line_width = =1.2 if raft_base_thickness == 0.5 else 1
raft_interface_speed = =speed_print * 3/10
raft_interface_z_offset = =-0.1 if raft_base_thickness == 0.5 else -0.05
raft_surface_flow = 110
raft_surface_infill_overlap = 50
raft_surface_line_spacing = 0.44
raft_surface_speed = =speed_print * 2/5
raft_surface_thickness = 0.27
raft_surface_z_offset = -0.075
retraction_min_travel = 5
retraction_speed = 1.75
speed_layer_0 = =speed_print * 1/5
speed_prime_tower = =speed_print * 1/5
speed_print = 50
speed_roofing = =speed_print
speed_support = =speed_print
speed_support_bottom = =speed_print * 1/5
speed_support_interface = =speed_print
speed_topbottom = =speed_print
speed_wall_0 = =speed_print
speed_wall_x = =speed_print
support_angle = 50
support_bottom_density = 99
support_bottom_line_width = 1.2
support_bottom_wall_count = =support_wall_count
support_conical_angle = 20
support_conical_enabled = True
support_conical_min_width = 20
support_fan_enable = False
support_infill_density_multiplier_initial_layer = 2
support_infill_rate = 12
support_interface_offset = 0
support_interface_wall_count = 2
support_offset = 1.8
support_pattern = zigzag
support_roof_density = 95
support_roof_height = =layer_height*8
support_roof_line_width = 0.4
switch_extruder_extra_prime_amount = 1
switch_extruder_retraction_amount = 2.5
switch_extruder_retraction_speeds = 3