[general]
definition = ultimaker_methodx
name = Fast
version = 4

[metadata]
material = ultimaker_pva_175
quality_type = draft
setting_version = 23
type = quality
variant = 2A
weight = -2

[values]
brim_replaces_support = False
cool_fan_enabled = False
cool_min_speed = 5
cool_min_temperature = =material_print_temperature
initial_layer_line_width_factor = 300
material_bed_temperature = 45
material_bed_temperature_layer_0 = 50
material_final_print_temperature = 210
material_initial_print_temperature = 210
material_print_temperature = 210
material_print_temperature_layer_0 = 220
material_standby_temperature = 160
prime_tower_flow = 125
raft_airgap = 0.0
raft_base_wall_count = 4
raft_interface_flow = 110
raft_interface_infill_overlap = 50
raft_interface_layers = 1
raft_interface_line_spacing = 0.9
raft_interface_line_width = 1
raft_interface_speed = 15
raft_interface_z_offset = -0.05
raft_surface_flow = 110
raft_surface_infill_overlap = 50
raft_surface_line_spacing = 0.44
raft_surface_line_width = 0.4
raft_surface_speed = 20
raft_surface_thickness = 0.27
raft_surface_z_offset = -0.075
retraction_speed = 1.75
speed_layer_0 = 10
speed_prime_tower = 10
speed_print = 50
speed_roofing = 50
speed_support = 50
speed_support_bottom = 10
speed_support_interface = 50
speed_topbottom = 50
speed_wall_0 = 50
speed_wall_x = 50
support_angle = 50
support_bottom_density = 99
support_bottom_height = 0.406
support_bottom_line_width = 1.2
support_bottom_wall_count = 2
support_conical_angle = 20
support_conical_min_width = 20
support_fan_enable = False
support_infill_density_multiplier_initial_layer = 2
support_infill_rate = 12
support_infill_sparse_thickness = =min(layer_height * 2, machine_nozzle_size * 3 / 4) if layer_height <= 0.15 / 0.4 * machine_nozzle_size else layer_height
support_interface_enable = True
support_interface_offset = 0.8
support_pattern = grid
support_roof_density = 95
support_roof_height = =layer_height*8
support_wall_count = 2
support_xy_distance = 0.2
support_z_distance = 0
switch_extruder_extra_prime_amount = 1
switch_extruder_retraction_amount = 2.5
switch_extruder_retraction_speeds = 3