[general]
definition = ultimaker_method
name = Fast
version = 4

[metadata]
material = ultimaker_pla_175
quality_type = draft
setting_version = 23
type = quality
variant = LABS
weight = -2

[values]
bottom_layers = 4
cool_fan_enabled = True
cool_fan_full_layer = 4
cool_fan_speed = 100
cool_fan_speed_0 = 0
cool_min_layer_time = 10
cool_min_speed = 5
cool_min_temperature = 205
infill_sparse_density = 15
material_final_print_temperature = 210
material_initial_print_temperature = 210
material_print_temperature = 210
material_print_temperature_layer_0 = 225
material_standby_temperature = 160
min_bead_width = =line_width * 0.75
min_wall_line_width = =line_width * 0.75
raft_airgap = 0.18
raft_base_line_spacing = 4
raft_base_line_width = 1.2
raft_base_speed = =raft_speed
raft_base_thickness = 0.6
raft_interface_fan_speed = 0
raft_interface_layers = 1
raft_interface_line_spacing = 0.75
raft_interface_speed = 60
raft_interface_thickness = 0.2
raft_speed = 30
raft_surface_fan_speed = 0
raft_surface_line_spacing = 0.425
raft_surface_speed = 90
raft_surface_wall_count = 2
retract_at_layer_change = True
skin_material_flow_layer_0 = =material_flow
speed_layer_0 = 15
speed_print = 150
speed_roofing = =speed_print / 3
speed_support = =speed_print
speed_support_interface = 65
speed_topbottom = =speed_print * 0.6
speed_wall = =speed_print / 6
speed_wall_0 = =speed_wall
speed_wall_x = =speed_wall
support_angle = 50.0
support_bottom_distance = =layer_height
support_bottom_enable = False
support_fan_enable = True
support_infill_angles = [45 ]
support_infill_rate = 12
support_infill_sparse_thickness = =layer_height
support_interface_density = 83
support_interface_height = =layer_height * 4
support_interface_material_flow = =material_flow * 0.9
support_interface_offset = 1
support_interface_wall_count = 0
support_line_width = line_width * 0.75
support_material_flow = =material_flow * 0.8
support_offset = 3
support_roof_density = =support_interface_density
support_roof_height = =layer_height * 4
support_roof_line_width = =line_width
support_roof_material_flow = =support_interface_material_flow
support_roof_wall_count = 1
support_xy_distance = 0.3
support_xy_distance_overhang = 0.1
support_xy_overrides_z = xy_overrides_z
support_z_distance = 0.15
switch_extruder_retraction_amount = 0.5
wall_0_material_flow_layer_0 = =material_flow
wall_x_material_flow_layer_0 = =material_flow