|
|
@@ -1208,7 +1208,7 @@ class BuildVolume(SceneNode):
|
|
|
_raft_settings = ["adhesion_type", "raft_base_thickness", "raft_interface_layers", "raft_interface_thickness", "raft_surface_layers", "raft_surface_thickness", "raft_airgap", "layer_0_z_overlap"]
|
|
|
_extra_z_settings = ["retraction_hop_enabled", "retraction_hop"]
|
|
|
_prime_settings = ["extruder_prime_pos_x", "extruder_prime_pos_y", "prime_blob_enable"]
|
|
|
- _tower_settings = ["prime_tower_mode", "prime_tower_size", "prime_tower_position_x", "prime_tower_position_y", "prime_tower_brim_enable", "prime_tower_base_size", "prime_tower_base_height"]
|
|
|
+ _tower_settings = ["prime_tower_enable", "prime_tower_size", "prime_tower_position_x", "prime_tower_position_y", "prime_tower_brim_enable", "prime_tower_base_size", "prime_tower_base_height"]
|
|
|
_ooze_shield_settings = ["ooze_shield_enabled", "ooze_shield_dist"]
|
|
|
_distance_settings = ["infill_wipe_dist", "travel_avoid_distance", "support_offset", "support_enable", "travel_avoid_other_parts", "travel_avoid_supports", "wall_line_count", "wall_line_width_0", "wall_line_width_x"]
|
|
|
_extruder_settings = ["support_enable", "support_bottom_enable", "support_roof_enable", "support_infill_extruder_nr", "support_extruder_nr_layer_0", "support_bottom_extruder_nr", "support_roof_extruder_nr", "brim_line_count", "skirt_brim_extruder_nr", "raft_base_extruder_nr", "raft_interface_extruder_nr", "raft_surface_extruder_nr", "adhesion_type"] #Settings that can affect which extruders are used.
|
Erwan MATHIEU