increase filter distance

Adding and splitting of lines results in print artefacts and additional travel moves. Avoiding these by sacrificing some additional line width change is better. The linewidth can never very more then 75% - 150%, so this long filter distance cannot cause huge line width changes. PP-129

resources/definitions/fdmprinter.def.json

@@ -1165,11 +1165,11 @@
                     "description": "If it would be transitioning back and forth between different numbers of walls in quick succession, don't transition at all. Remove transitions if they are closer together than this distance.",
                     "type": "float",
                     "unit": "mm",
-                    "default_value": 1.4,
-                    "value": "4 * math.cos(wall_transition_angle / 180 * math.pi) * wall_line_width_x",
+                    "default_value": 100,
+                    "value": "100",
                     "minimum_value": "wall_transition_length",
                     "minimum_value_warning": "math.cos(wall_transition_angle / 180 * math.pi) * wall_line_width_x",
-                    "maximum_value_warning": "10 * math.cos(wall_transition_angle / 180 * math.pi) * wall_line_width_x"
+                    "maximum_value_warning": "999999"
                 },
                 "wall_0_wipe_dist":
                 {

resources/setting_visibility/expert.cfg

@@ -30,6 +30,7 @@ wall_thickness
 wall_line_count
 wall_0_wipe_dist
 wall_0_inset
+wall_transition_filter_distance
 optimize_wall_printing_order
 inset_direction
 alternate_extra_perimeter