Normalise print temperature so that normal quality is at default temperature

All print temperatures go down 5 degrees and then in the material profile the temperature is increased by 5. This gives the normal profile a +0 instead of +5.

Contributes to issue CURA-3433.

resources/quality/ultimaker3/um3_aa0.4_CPEP_Draft_Print.inst.cfg

@@ -19,7 +19,7 @@ machine_nozzle_cool_down_speed = 0.9
 machine_nozzle_heat_up_speed = 1.4
 material_initial_print_temperature = =material_print_temperature - 5
 material_final_print_temperature = =material_print_temperature - 10
-material_print_temperature = =default_material_print_temperature + 10
+material_print_temperature = =default_material_print_temperature + 5
 prime_tower_size = 17
 retraction_combing = off
 retraction_hop = 0.2

resources/quality/ultimaker3/um3_aa0.4_CPEP_Fast_Print.inst.cfg

@@ -19,7 +19,7 @@ machine_nozzle_cool_down_speed = 0.9
 machine_nozzle_heat_up_speed = 1.4
 material_initial_print_temperature = =material_print_temperature - 5
 material_final_print_temperature = =material_print_temperature - 10
-material_print_temperature = =default_material_print_temperature + 10
+material_print_temperature = =default_material_print_temperature + 5
 prime_tower_size = 17
 retraction_combing = off
 retraction_hop = 0.2

resources/quality/ultimaker3/um3_aa0.4_CPEP_High_Quality.inst.cfg

@@ -16,7 +16,7 @@ infill_wipe_dist = 0
 layer_height = 0.06
 material_initial_print_temperature = =material_print_temperature - 5
 material_final_print_temperature = =material_print_temperature - 10
-material_print_temperature = =default_material_print_temperature + 2
+material_print_temperature = =default_material_print_temperature - 3
 prime_tower_size = 17
 retraction_combing = off
 retraction_hop = 0.2

resources/quality/ultimaker3/um3_aa0.4_CPEP_Normal_Quality.inst.cfg

@@ -15,7 +15,7 @@ cool_min_speed = 7
 infill_wipe_dist = 0
 material_initial_print_temperature = =material_print_temperature - 5
 material_final_print_temperature = =material_print_temperature - 10
-material_print_temperature = =default_material_print_temperature + 5
+material_print_temperature = =default_material_print_temperature
 prime_tower_size = 17
 retraction_combing = off
 retraction_hop = 0.2