Remove lower warnings from Jerk settings

It's sometimes required to be extra careful, and the difference between 0 and 5 isn't that big that it would cause a great increase in print time.

resources/definitions/fdmprinter.def.json

@@ -2555,7 +2555,6 @@
                                             "default_value": 20,
                                             "value": "jerk_support_interface",
                                             "minimum_value": "0.1",
-                                            "minimum_value_warning": "5",
                                             "maximum_value_warning": "50",
                                             "enabled": "resolveOrValue('jerk_enabled') and extruderValue(support_roof_extruder_nr, 'support_roof_enable') and support_enable",
                                             "limit_to_extruder": "support_roof_extruder_nr",
@@ -2571,7 +2570,6 @@
                                             "default_value": 20,
                                             "value": "jerk_support_interface",
                                             "minimum_value": "0.1",
-                                            "minimum_value_warning": "5",
                                             "maximum_value_warning": "50",
                                             "enabled": "resolveOrValue('jerk_enabled') and extruderValue(support_bottom_extruder_nr, 'support_bottom_enable') and support_enable",
                                             "limit_to_extruder": "support_bottom_extruder_nr",